Ada Fitting Room Bench Height

Partitions and doors should be designed to ensure people using accessible dressing and fitting rooms privacy equivalent to that afforded other users of the facility.

Ada fitting room bench height.

Benches shall have back support that is 42 inches 1065 mm minimum in length and that extends from a point 2 inches 51 mm maximum above the seat to a point 18 inches 455 mm minimum above the seat see fig. To ensure ada compliance the bench should be mounted between 17 to 19 inches in height. Benches must be 42 inches long between 20 and 24 inches deep and 17 to 19 inches high. So providing the clear floor space at the end of the bench as required by the 2010 standards instead of in front of the bench as is allowed by the 1991 standards would only be required when the bench in the accessible dressing room is altered or when the entire dressing room area is altered.

Section 903 5 requires dressing room bench seats to be installed so that they are at the same height as a typical wheelchair seat 17 inches 430 mm to 19 inches 485 mm. The only outdoor bench related ada guidelines are in the united states access board revised draft guidelines chapter r3. Where benches without tables are provided at a single location at least 50 percent but no fewer than one shall have a seat height at the front edge of 43 cm 17 in minimum and 49 cm 19 in maximum above the ground or floor space. Although not currently an enforceable ada standard the guideline specifies a bench seat height of 17 inches minimum and 19 inches maximum above the ground or floor space.

According to ansi 803 4 and ada 4 35 4 a bench is required in all accessible fitting rooms. The top of the bench seat surface shall be 17 inches 430 mm minimum and 19 inches 485 mm maximum above the finish floor or ground. 222 dressing fitting and locker rooms. Bench seats shall be 17 inches 430 mm minimum to 19 inches 485 mm maximum above the floor or ground.

This dressing bench mounts with mounting flanges.